Print Settings

Use Bambu's built-in PLA profile. Input shaper enabled.

Use PrusaSlicer's 0.2mm QUALITY profile for best results.

Input shaper enabled. Reduce speed if ghosting appears.

Apply glue stick to PEI bed to prevent over-adhesion.

Reduce fan speed for better layer adhesion on structural parts.

Enclosure required. Close all doors and vents.

Reduce speed significantly. Disable AMS — feed directly.

Hardened steel nozzle required. Dry filament 8hrs at 65°C.

Use Bambu's built-in PLA profile. Enclosed chamber not needed for PLA.

Adaptive Airflow System seals chamber. Excellent ABS results with carbon filter active.

Full-auto calibration handles setup. Use Bambu PLA for RFID auto-config.

Use Bambu's built-in PLA profile. Excellent results out of the box.

Input shaper calibration recommended before first print.

Apply glue stick to PEI bed. Excellent results with Bambu PETG HF.

Reduce speed for best results. Glue stick prevents over-adhesion.

Enclosure required. Close all doors and vents. Excellent ABS results.

Direct drive makes MK4 excellent for TPU. Very slow speeds required.

Enclosure required. Similar to ABS profile. Excellent outdoor part results.

Dry 12+ hours at 70°C. Enclosure required. Use Bambu's PA profile.

Slightly higher temp than standard PLA. Use PLA profile as base.

Use PLA profile in PrusaSlicer. Increase temp by 5°C vs standard PLA.

Hardened steel nozzle required. Dry 6hrs at 65°C. Excellent stiffness.